How to Get LED Turn Signals to Blink Slowly
LED turn signals have become increasingly popular in modern vehicles due to their energy efficiency and durability. However, many drivers prefer the traditional fast blinking of turn signals to indicate a turn. If you are one of those drivers and want to get your LED turn signals to blink slowly, follow these simple steps.
Firstly, you need to locate the turn signal relay. This is usually found in the engine compartment, and it’s responsible for controlling the blinking rate of the turn signals. Once you have located the relay, disconnect the electrical connections to it.
Next, you will need to access the relay’s internal components. The relay contains a coil and a set of contacts. The coil is responsible for controlling the blinking rate of the turn signals. To slow down the blinking, you need to increase the resistance in the circuit.
To do this, you can add a resistor in series with the relay coil. The value of the resistor will depend on the relay’s specifications and the desired blinking rate. You can use a multimeter to measure the resistance of the relay coil and then choose an appropriate resistor value. For example, if the relay coil has a resistance of 100 ohms and you want the turn signals to blink at a slower rate, you might use a 200-ohm resistor.
After choosing the resistor, connect it in series with the relay coil. Make sure to connect the resistor’s positive lead to the relay coil’s positive terminal and the negative lead to the relay coil’s negative terminal. Reconnect the electrical connections to the relay.
Now, test the turn signals to see if they are blinking at the desired slow rate. If the turn signals are still blinking too fast, you may need to adjust the resistor value. If the turn signals are too slow, you can add another resistor in parallel with the existing one to decrease the overall resistance.
Remember to consult your vehicle’s manual or seek professional assistance if you are unsure about the specific requirements for your vehicle’s relay. Additionally, it’s essential to ensure that the modified turn signals comply with local traffic regulations to avoid any legal issues.
In conclusion, getting your LED turn signals to blink slowly is a straightforward process that involves adding a resistor in series with the relay coil. By adjusting the resistor value, you can achieve the desired blinking rate. Just make sure to follow the proper steps and consult your vehicle’s manual or a professional if needed. Happy driving!
